Alto Las BalsasVilla La Angostura · Patagonia
EN
← Back to the guide

Hemmel wifi thermostat

Underfloor heating

Thermostat display showing the room temperature, the target temperature and the buttons below

The cabin is heated by hot water circulating through pipes beneath the floor. The thermostat is set to 19 °C: we recommend leaving it there; it is a comfortable temperature and the system runs efficiently.

If you feel cold

  1. Tap the ▲ arrow on the thermostat. Each tap raises the target temperature.
  2. If you went too far, tap the ▼ arrow to lower it.

Be patient: because the heat travels through the floor and the building structure, the change may take more than 12 hours to be fully felt. It is not an instant-response heater.

Avoid raising and lowering the thermostat repeatedly. Sudden changes do not make the floor heat up or cool down faster.

There is no need to touch the other buttons. The ⏻ button switches the thermostat off: if you switch it off, the cabin stops being heated.

If it is too warm

The thermostat may be set to 19 °C while it is, for example, 28 °C inside. This is not a fault. There are two reasons:

The thermostat can only switch the heating on or off. When it is warmer inside than the target temperature, the heating is already off. That is why lowering the thermostat does not cool the cabin: it only means that, once it gets cooler, it will take many more hours to warm up again.

What to do:

  1. Ventilate. Open the windows if the weather outside allows it.
  2. Wait for the evening. As the sun goes down, the temperature gradually returns to the set value.
  3. Leave the thermostat at 19 °C.

Reading the thermostat

The display shows two temperatures:

Didn’t work?